Wall End Brackets is rated
Rated 1 out of
The Screws are Terrible
The screws supplied with these brackets are absolutely unacceptable. You couldn't do this bad of a job without trying. Flat head screws are terrible at the best of times, but the slots in these are so low profile that you can't turn them. If you buy any of this stuff, understand that you will need a hacksaw and cut your own slots in the screws, in order for them to work like screws.
Date published: 2019-04-29
Rated 5 out of
Great product, easy installation
Awesome product, leveled and marked all of my holes and popped everything right in. The longest part of the whole installation was cutting the shelves. As for the other reviewer who was complaining about the screws, LOL, reading instructions is a skill, they aren’t screws they are drive pins.
Date published: 2018-01-10
Rated 1 out of
Bracket is too deep for proper shelf support
The depth of the bracket is greater than the depth of the front lip of the 16" shelf by this same manufacturer. The thinner shelf wire sits on the edge of the bracket whereas the thicker wire should set firmly on the bottom of the bracket. Notice the bracket picture shown for the fast track version, it appears that the thick slide rail rests firmly on the inside bottom of the bracket. I have the standard shelf (and standard bracket), and only a single thin shelf wire is supporting the shelf on the upper inside edge of the bracket. Perhaps the shelf lip width was shortened without doing the same for the bracket? Notching the bracket could make it work, but why is it designed so poorly to begin with?
BTW, package directions are also poor. They do not specify the relationship between the shelf height and the height of the holes for the rear or side brackets. They don't even mention the distance between the two anchors on the end bracket. Because the brackets are integral with the wall board anchors, the bracket cannot be pre-positioned to mark where the holes belong.
Date published: 2017-12-31
Rated 2 out of
Slotted screws in the end brackets are junk. Brand new screwdriver couldn't put one in without camming out. Get a different supplier and switch to Phillips.
Date published: 2017-06-30